RIETH CREATIONS

The exhaust cone and rear of the jet engine should have the same diameter. If gluing the flaps in the lowered position, you can see the...

I am making some modifications as I test build another Banshee to improve the fit of the resin to KH parts. I decided to do something...

The nose gear fork, B78, needs to be shortened. The square bottom of strut, B57, should be at the front curve of the fork. Parts C56 and...

If displaying the Banshee with the gun bay doors open and nose cone off, the nose gun bay needs to be modified to use the resin parts....

REMINDER: Glue the KH cockpit, nose gear well, and part C62 to the KH fuselage. Glue the revised resin rear fuselage to the KH front...

I've revised where to cut the fuselage after feedback and I have made the rear fuselage a one piece hollow cast part. Gently scribe...

The upper and lower wings were cut from the casting sprue and some resin runner material was left to protect the edges and corners from...

For easier fitting and gluing of the resin intakes to resin wing, it is advised that the jet engines be cut apart. Paint engine interior...

While doing additional research for the Resin Correction Set, I was looking at the wing to tip tank area and realized that I had glued...